Philips CD Player AQ414 User Manual

AQ4140  
Radio Cassette Recorder  
Register your product and get support at  
User Manual  
 
English  
Controls/Power Supply  
Congratulations on your purchase and  
welcome to Philips!  
Back panel (See 1)  
8 Telescopic antenna  
To fully benefit from the support that  
Philips offers, register your product at  
- improves FM/SW reception.  
9 AC IN ~ - inlet for power cord  
0 Voltage selector – (inside the battery  
compartment, not for all versions) adjust to  
match the local voltage 110/220V before  
plugging in the set.  
Supplied accessories  
AC power cord  
Top and front panels (See 1)  
1 Cassette recorder keys:  
! Battery door - open to insert 4 X 1.5  
batteries, type R20 or D-cells  
PAUSE ;  
pauses playback or recording  
STOPEJECT 9  
/
Power supply  
stops playback or recording.  
opens the cassette holder.  
Whenever convenient, use the power cord if  
you want to conserve battery life. Make sure  
you remove the plug from the set and wall  
outlet before inserting batteries.  
F.FWD/REWIND 5 or 6  
fast winds/rewinds the tape  
PLAY 1 starts playback  
RECORD 0 starts recording  
Batteries (not included)  
Insert 4 batteries, type R20 or D-cells  
(preferably alkaline) with the  
correct polarity. (See 1)  
2 p - 3.5mm stereo headphone jack  
Helpful hints:  
Connecting the headphones will switch off  
the speakers.  
Batteries contain chemical substances,  
so they should be disposed of properly.  
3
4
TONE  
RADIO (SW) only: for fine tuning  
Source selector:TAPE (Off), RADIO  
Incorrect use of batteries can cause  
electrolyte leakage and will corrode the  
compartment or cause the batteries to burst:  
-
Do not mix battery types: e.g. alkaline with  
carbon zinc. Only use batteries of the same  
type for the set.  
selects tape or radio source of sound  
switches off the set  
When inserting new batteries, do not try to  
mix old batteries with the new ones.  
Band selector: MW, SW, FM  
selects wavebands, MW, SW or FM  
Remove the batteries if the set is not to be  
used for a long time.  
5 VOLUME rotary – adjusts volume level  
6 TUNING rotary – tunes to radio stations  
7 MIC (built-in microphone)  
for voice recording  
 
Power Supply  
General Operation/Radio  
Using AC power  
General operation  
Switching on and off and selecting  
functions  
1
Check if the power voltage, as shown on  
the type plate located on the  
bottom of the set, corresponds to your  
local power supply. If it does not, consult  
your dealer or service center.  
1
2
To switch on, push the Source selector  
slider to TAPE or RADIO as desired.  
To switch off, push the Source selector  
to TAPE and check the cassette  
keys are released.  
2
3
If your set is equipped with a voltage  
selector, adjust the selector so that it  
matches with the local mains.  
Helpful hints:  
Connect the power cord to the AC IN ~  
inlet and the wall socket.The power cord is  
now connected and ready for use.  
To change from TAPE to RADIO , or when  
you are switching off the set: first, make sure  
you press the STOPEJECT 9/ key to end  
playback and all the cassette keys are released.  
4
To switch the set off completely, withdraw  
the power cord from the wall socket.  
Disconnect the power cord from the wall  
socket to protect your set during heavy  
thunderstorms.  
Adjusting volume  
Adjust the volume with the VOLUME  
control.  
Helpful hints : To avoid unnecessary energy  
consumption, always adjust the Source  
selector to TAPE (OFF) after using the  
set. Also check that the tape deck keys are  
released.  
Radio reception  
1
2
Adjust the source selector to RADIO.  
Adjust the band selector to select your  
desired waveband, MW, SW or FM.  
3
4
Turn TUNING to tune to a station.  
•In SW, turnTONE for precise tuning.  
The type plate is located on the bottom  
of the set.  
To switch off the radio, adjust the source  
selector to TAPE position.  
To improve radio reception:  
For FM and SW, extend and turn the  
telescopic antenna for best reception.  
Reduce its length if the signal is too strong.  
For MW, the set uses a built-in antenna.  
Direct this antenna for best reception by  
turning the whole set.  
CAUTION  
Use of controls or adjustments or  
performance of procedures other than  
herein may result in hazardous radiation  
exposure or other unsafe operation.  
 
Cassette Recorder  
General information on recording  
Cassette playback  
Recording is permissible insofar as copyright  
or. other rights of third parties are not  
infringed.  
1
2
Push the Source selector slider to TAPE  
Press STOPEJECT 9/ to open the  
cassette holder and insert a cassette and  
close the deck.  
For recording, use only NORMAL type cas-  
settes (IEC type I) on which the tabs have  
not yet been broken.This deck is not suited  
for recording on CHROME (IEC II) or  
METAL (IEC IV) type cassettes.  
3
4
Press PLAY 1 to start playback.  
To pause playback press PAUSE ;  
.
To resume, press the key again.  
5
By pressing F.FWD/REWIND 5 or 6  
fast forwading/ rewinding of the tape is  
possible in both directions.To stop fast  
winding, press 9//.  
,
The best recording level is set automatically.  
Altering the VOLUME will not affect the  
recording.  
To protect a tape from accidental erasure,  
break out the tabs. If you wish to record again,  
cover the tabs with a piece of adhesive tape.  
6
To stop the tape, press 9//.  
Helpful hints:  
During playback, the keys are automatically  
released at the end of a tape and the set is  
Recording from the Radio  
switched off (unless PAUSE ; mode has been  
activated.)  
1
2
Select RADIO source.  
Tune to the desired radio station (see Radio  
reception).  
During fast forwarding/rewinding, the keys will  
not be released at the end of a tape.To switch  
off the set, make sure the cassette keys are also  
released.  
3
Press 9// to open the cassette holder.  
Insert a blank tape and close the deck.  
4
5
Press REC 0 to start recording.  
For brief interruptions press  
;.  
To resume recording, press  
;
again.  
6
To stop recording, press 9//.  
Making your recording  
The making of unauthorized copies of  
copy-protected material, including com-  
puter programmes, files, broadcasts and  
sound recordings, may be an infringe-  
ment of copyrights and constitute a  
criminal offence.This equipment should  
not be used for such purposes.  
1
2
Select TAPE source.  
Follows steps 3-4 under Recording from  
the Radio.  
3
4
Speak towards the built-in microphone  
MIC (see 1).  
Follows steps 6-7 under Recording from  
the Radio.  
 
Maintenance & safety  
Tape deck maintenance  
To ensure quality recording and playback of  
the tape deck, clean parts A, B and C as  
shown, once a month. Use a cotton bud  
slightly moistened with alcohol or a special  
head cleaning fluid to clean the deck.  
Open the cassette holder by pressing 9/.  
Press 1 and clean the roller C.  
Hearing Safety  
1
2
3
Listen at a moderate volume.  
Using headphones at a high volume can  
impair your hearing. This product can pro-  
duce sounds in decibel ranges that may cause  
hearing loss for a normal person, even for  
exposure less than a minute. The higher deci-  
bel ranges are offered for those that may  
have already experienced some hearing loss.  
Press  
;
and clean the heads A, and the  
capstan B.  
After cleaning, press 9/.  
Cleaning of the heads can also be done by  
playing a cleaning cassette through once.  
4
C
B
A
A
Sound can be deceiving. Over time your  
hearing "comfort level" adapts to higher vol-  
umes of sound. So after prolonged listening,  
what sounds "normal" can actually be loud  
and harmful to your hearing. To guard against  
this, set your volume to a safe level before  
your hearing adapts and leave it there.  
Safety information  
Place the set on a flat, hard and stable surface  
so that the system does not tilt.  
Where the MAINS plug or an appliance cou-  
pler is used as the disconnet device, the dis-  
connet device shall remain readily operable.  
Do not expose the set, batteries to humidity,  
rain, sand or excessive heat caused by heating  
equipment or direct sunlight.  
The apparatus shall not be exposed to  
dripping or splashing.  
Adequate ventilation with a minimum gap  
of 15cm (6 inches) between the ventilation  
holes and surrounding surfaces is necessary  
to prevent heat build-up.  
To establish a safe volume level:  
Set your volume control at a low setting.  
Slowly increase the sound until you can hear  
it comfortably and clearly, without distortion.  
Listen for reasonable periods of time:  
Prolonged exposure to sound, even at nor-  
mally "safe" levels, can also cause hearing loss.  
Be sure to use your equipment reasonably  
and take appropriate breaks.  
Be sure to observe the following  
guidelines when using your head-  
phones.  
Do not cover the ventilation openings with  
items such as newspapers, table-cloths,  
curtains, etc.  
No objects filled with liquids, such as vases,  
shall be placed on the apparatus.  
No naked flame sources, such as lighted  
candles, should be placed on the apparatus.  
The mechanical parts of the set contain  
self-lubricating bearings and must not be  
oiled or lubricated.  
Listen at reasonable volumes for reasonable  
periods of time.  
Be careful not to adjust the volume as your  
hearing adapts.  
Do not turn up the volume so high that you  
can't hear what's around you.  
You should use caution or temporarily  
discontinue use in potentially hazardous  
situations.  
To clean the set, use a dry cloth. Do not  
use any cleaning agents containing alcohol,  
ammonia, benzene or abrasives as these  
may harm the housing.  
Do not use headphones while operating a  
motorized vehicle, cycling, skateboarding, etc.;  
it may create a traffic hazard and is illegal in  
many areas.  
 
Troubleshooting  
If a fault occurs, first check the points listed below before taking the set for repair.  
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.  
WARNING:  
Do not open the set as there is a risk of electric shock. Under no  
circumstances should you try to repair the set yourself, as this will  
invalidate the guarantee.  
Problem  
Poor radio reception  
Weak radio signal  
Possible cause  
FM/SW:Adjust the FM telescopic antenna  
MW: Direct this antenna for best reception  
by turning the whole set.  
• Remedy  
No sound /power  
Volume not adjusted  
• Adjust theVOLUME  
Poor cassette sound quality  
Power cord not securely connected  
• Connect the AC power cord properly  
Batteries dead/ incorrectly inserted  
• Insert (fresh) batteries correctly  
Headphones connected to the set  
Dust and dirt on the heads, etc.  
• Clean deck parts, see Maintenance  
Use of incompatible cassette types (METAL or  
CHROME)  
Disconnect headphones.  
• Only use NORMAL (IEC I) for recording  
Display does not function properly/  
No reaction to operation of any of the  
controls  
Recording does not work  
Cassette tab(s) may be broken  
Electrostatic discharge  
• Apply adhesive tape over the missing tab space  
• Switch off and unplug the set. Reconnect after a  
few seconds  
Severe radio hum or noise  
Electrical interference: set too close to TV,VCR or  
computer  
Increase the distance.  
Environmental information  
All unnecessary packaging material has been omitted.The packaging can be easily  
separated into three materials: cardboard, polystyrene and plastic.  
Your set consists of materials which can be recycled if disassembled by  
a specialized company. Please observe the local regulations regarding  
the disposal of packaging, dead batteries and old equipment.  
 
Meet Philips at the Internet  
W
AQ4140  
Printed in China  
PDCC-ZXJ-0802  
 

Pella Window 812WO100 User Manual
Philips Baby Accessories SCF172 20 User Manual
Philips CRT Television 14PT2118 User Manual
Philips Indoor Furnishings 36800 48 36 User Manual
Philips VCR VRZ244 User Manual
Planar Computer Monitor PL2010MW User Manual
Polaroid Flat Panel Television FLU 1514SA User Manual
Poulan Snow Blower PP5524ESA User Manual
Pride Mobility Network Card Dynamic DX User Manual
ProForm Home Gym 831286220 User Manual