Primera Technology Laminator 510893 021505 User Manual

IMPORTANT:  
Due to the wide variety of media you may need to adjust the heat setting of your laminator to get the  
best transfer. If the laminate is not fully transferring to the disc, the heat must be increased. However,  
if the heat is set too high, the printed image on the disc may be distorted. Excessive heat may  
even cause the label side to peel off of the disc. Because of this you should use the least amount of  
heat necessary to transfer the laminate film to the surface of your disc.  
CD/DVD Optical  
Adjusting the Center Hub  
4
Disc Laminator  
1. If the laminate is not adhering to the  
hub in the same manner as the rest  
of the disc, you may wish to avoid  
laminating the center hub. To do this,  
lift the Tray Disc Hub Spacer from the  
center of the Disc Tray and rotate it  
slightly clockwise. Place it back into  
the center of the Disc Tray making  
certain it seats properly in the tray.  
2. Repeat the test with another disc.  
When you are satisfied with the  
setting, you may want to make a note  
of them for future reference. You are  
now ready to laminate your discs.  
Disc Hub Spacer  
Disc Surface  
Disc Present  
Sensor  
With the Disc Tray Hub in this  
position, laminate will be  
transferred to the hub of the  
disc.  
Hub is even with  
disc surface  
Disc Surface  
Sensor  
With the Disc Tray Hub in  
this position, laminate will  
NOT be transferred to the  
hub of the disc.  
Hub is  
recessed to  
disc surface  
Disc Surface  
Sensor  
© 2005 All rights reserved.  
P/N 510893-021505  
 

Philips Battery Charger SCB5365NB User Manual
Philips Stereo System DCB852 User Manual
Pioneer Stereo Receiver CT L77 User Manual
Pioneer Stereo Receiver XRE3138 A User Manual
Polaris Offroad Vehicle 600 IQ Racer User Manual
Polaroid Digital Camera PDC 3350 User Manual
Poulan Lawn Mower 187080 User Manual
Pride Mobility Motor Scooter INFINFB2039 User Manual
ProForm Home Gym PFEL39014 User Manual
ProForm Treadmill PFTL998064 User Manual